Lcd Error Messages - Samsung SF 5100 User Manual

07-Troubleshooting
Display
DOCUMENT JAM
DOOR OPEN
FUSER ERROR
JAM/NO CARTRIDGE
LINE ERROR
LOAD DOCUMENT !
LSU ERROR
MEMORY FULL
NO ANSWER
NO. NOT ASSIGNED
NO PAPER
OVER HEAT
12/10/99 5:42 AM Page 7

LCD error messages

Meaning
The loaded document has jammed
in the feeder.
The top cover is not securely
latched.
There is a problem in the fuser
unit.
Recording paper has jammed
inside the unit, or the toner
cartridge is not installed.
Your unit cannot connect with the
remote machine, or has lost con-
tact because of a problem on the
phone line.
You have attempted to set up a
sending operation with no docu-
ment loaded.
A problem has occurred in the
LSU (Laser Scanning Unit).
The memory is full.
The remote machine has not
answered after all the redial
attempts.
The one-touch or speed dial loca-
tion you tried to use has no num-
ber assigned to it.
The recording paper has run out.
The printer part in your unit
has overheated.
Solution
Clear the document jam.
Press down on the cover until
it clicks in place.
Unplug the power code and plug
it back in. If the problem still per-
sists, please call for service.
Clear the jam, or install the
cartridge.
Try again. If failure persists, wait
an hour or so for the line to clear,
then try again.
Or, turn the ECM mode on. See
'System setup' on page 5.5.
Load a document and try again.
Unplug the power cord and plug
it back in. If the problem still per-
sists, please call for service.
Either delete unnecessary docu-
ments, or retransmit after more
memory becomes available, or
split the transmission into more
than one operation.
Try again. Make sure the remote
machine is operational.
Dial the number manually with
the keypad, or assign a number.
Load the recording paper.
Please wait until it cools down.
If you cannot solve the problem,
please call for service.
Troubleshooting
6.5