Samsung CLX-8380ND User Manual page 110

Message Meaning
Sensor failure:
There is a problem
[zzz]. Call for
in the sensor signal.
service
Shake [xxx] toner
The toner supply is
cartridge
low.
Staple cartridge is
Stapler is run out.
empty. Replace it
Staple cartridge is
The staple cartridge
not installed.
is not installed.
Install it in finisher
System error:
There is a problem
[zzz]. Please turn
in the system
off then on
operation.
This IP address
The IP address is
conflicts with an IP
used in other place
address already in
elsewhere.
use. Check it
Too much paper in
The stacker is full of
finisher stacker.
printouts.
Remove printed
paper
Too much paper in
The printed papers
output bin tray.
are full on the output
Remove printed
tray.
paper
Transfer belt is not
The transfer belt of
the machine is not for
valid for this
your machine.
machine. Check
user? guide
Transfer belt unit
The life of the
transfer belt expires
is worn. Replace it
totally.
Suggested solutions
Turn the machine off
and turn it on again. If
the problem persists,
please call for
service.
Thoroughly roll the
new cartridge five or
six times to distribute
the toner evenly
inside the cartridge.
(Page 11.3)
Order Staple
Cartridge.
(Page 13.2) And
replace it.
(Page 14.2)
Install the staple
cartridge following
the steps explained
on the back of the
finisher door.
(Page 14.2) If you
want to continue the
print job and
disregard of this error
message, go to
Admin Setting to
adjust the option.
(Page 10.2)
Turn the machine off
and turn it on again. If
the problem persists,
please call for
service.
Check the IP address
or obtain a new IP
address.
Remove printouts
from the stacker.
Remove printed outs
from the output tray.
Install the a
Samsung-genuine
part designed for your
machine.
Replace the part with
a new one. Call for
service.
12.14
Message Meaning
Waste tank is full. The life span of the
Replace it waste toner
container has
expired and the
printer will stop
printing until a new
waste toner
container is placed
into the printer.
USE AUXILIARY The credit is not
ACCESS enough to access
the job according to
Foreign Device.
<Troubleshooting>
Suggested solutions
Replace a waste
toner container with a
Samsung-genuine
waste toner
container.
(Page 11.7)
Insert credit into the
Foreign Device.