Verifying The Local Policy-Based Routing Configuration; Configuration Example For Local Policy-Based Routing; Feature History For Local Policy-Based Routing - Cisco Nexus 7000 Series Configuration Manual

Verifying the Local Policy-Based Routing Configuration

Step 4
Step 5
Verifying the Local Policy-Based Routing Configuration
To display the local policy-based routing configuration, perform the following task:
Command
show ipv6 local policy
show route-map name
For detailed information about the fields in the output from these commands, see the Cisco Nexus 7000 Series
NX-OS Quality of Service Command Reference.

Configuration Example for Local Policy-Based Routing

This example shows how to configure a simple local route policy on an interface:
feature pbr
route-map Testmap, permit, sequence 10
ip address 10
ip next-hop
ip precedence: internet

Feature History for Local Policy-Based Routing

The table below summarizes the new and changed features for this document and shows the releases in which
each feature is supported. Your software release might not support all the features in this document. For the
latest caveats and feature information, see the Bug Search Tool at
release notes for your software release.
Table 44: Feature History for Local Policy-Based Routing
Feature Name
Local Policy-Based Routing
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
156
Command or Action
(Optional) switch(config)# show ipv6 local
policy
(Optional) switch(config)# copy
running-config startup-config
Release
6.2(2)
Configuring Local Policy-Based Routing
Purpose
Displays information about the policy.
Saves this configuration change.
Purpose
Displays information about the local IPv6 policy.
Displays information about a route map.
https://tools.cisco.com/bugsearch/
Feature Information
This feature was introduced.
and the