Install The Booster - NETGEAR WN1000RP User Manual

The bottom of the booster has the following feature:
• Factory Reset button. To use this button, stick a paper clip into the reset hole and hold it
until the Status LED blinks. Then release the button.

Install the Booster

To install the booster:

1 Either connect the AC plug, or attach the stand and the power adapter cord.
2 Find a place to install the booster that is about halfway between the router and the computer
or wireless device that is outside of the range of the router.
If you have to use a different location, see
3 Power up the booster.
• If you connected the AC plug to the booster, plug it directly into an electrical outlet.
• If you attached the stand and power adapter, plug the power adapter into an electrical
outlet.
4 Wait until the Status LED
5 Use a computer or wireless device to connect to the booster. During installation, it might be
easier to use a computer or device that is in the same room as the booster.

For a wireless connection, use a WiFi network manager to find and connect to
NETGEAR_EXT (the SSID) wireless network.
Tip: You can use any WiFi network manager utility on a computer or tablet to
find and connect to the booster wireless network.
After the connection with the computer is established, the PC to Booster LED
green.
WiFi Booster for Mobile WN1000RP
Position the Booster
turns green.
Getting Started
7
on page 8.
turns