Operation; Module View; Display; Pushbuttons / Additional Functions - Siemens SE25M575GB series Repair Instructions

3

OPERATION

3.1

Module view

3.2

Display

The display consists of a 3-digit 7-segment display. The expected re-
maining running time is displayed in hours and minutes.
815_58300000003806_ara_en_e.doc – 30.01.12
The remaining running time is recalculated at the end of the heating
positions. If deviations occur on account of the aqua sensor decisions,
water supply temperature, number of utensils, etc., the indicated
remaining running time is corrected in these positions. Time jumps of
up to 60 minutes may occur. At the start of the programme the
remaining running time is displayed which was required by this
programme the last time.
3.3

Pushbuttons / Additional functions

3.3.1 Timer programming (TP)
The timer programming button enables the start time to be delayed by
up to 24 h
3.3.2 Soaking (optional)
The "soaking" button can also be selected for any rinse programme. If
the button is pressed, an additional prerinse occurs and the bottom
basket is heated to 55°. This causes the running time to be extended
by approx. 20 min. Recommended for mixed utensils (top basket: fragile
utensils / bottom basket: very dirty non-fragile utensils).
3.3.3 Top basket (optional)
The top basket button must be pressed if only the top basket is to be
rinsed. The water points are positioned for top basket rinsing through-
out the rinse cycle. However, the programme sequence is the same
as for alternate rinsing.
3.3.4 Time reduction (optional)
The time reduction button can also be selected for any programme.
When the button is pressed, the circulation and drying times and
therefore the rinsing and drying performance are reduced
Seite 5 von 67