Water Points (Optional) - Siemens SE25M575GB series Repair Instructions

4.21

Water points (optional)

A Microswitch
B Cam disc
C Locking disc
The water points are responsible for alternate rinsing (appliance rinses
alternately in the top and bottom basket, bottom basket 60 sec. / top
basket 55 sec., changeover lasts approx. 5 sec.).
815_58300000003806_ara_en_e.doc – 30.01.12
This kit consists of:
► Synchronous motor with gears
► Cam disc (B)
► Microswitch (A)
► Locking disc (C)
The synchronous motor is actuated via a triac. The synchronous
motor drives the gears, the cam disc (B) and the locking disc (C). The
locking disc (C) locks the relevant water channel to the spray arms.
The locking disc (C) has two openings which differ in size. The smaller
opening reduces the flow rate to the top basket. The controller
receives information on the position of the locking disc (C) from the
microswitch (A) which is actuated by the cam disc (B).
The water points are integrated in the instantaneous
water heater and may be replaced as a complete unit
only.
Technical specifications:
Designation
Nominal voltage (synchronous motor)
Frequency
Resistor
Value Unit
230–240 V
50 / 60 Hz
approx. 9.3
kΩ
Seite 32 von 67