Controls And Functions - Eizo RadiForce GX560 Instructions For Use Manual

1-3. Controls and Functions

1
Approx. 30°
3
1. Integrated Front Sensor
(Movable)
2. Ambient Light Sensor
3. Presence Sensor
4. Operation switches
5. switch
6. USB upstream port
7. DVI-D connector
8. DisplayPort input
connector
9. DisplayPort output
connector
10. Power connector
11. USB downstream port
12. Stand
13. Main power switch
14. Security lock slot
15. Cable holder
2
11
4 5
This sensor is used to perform calibration and Grayscale Check.
This sensor measures environmental illumination. Environmental illuminance
measurement is performed using the RadiCS / RadiCS LE quality control software.
This sensor detects movements made by a person in front of the monitor.
Displays the operation guide. Set menus according to the operation guide.
Turns the power on or off.
The switch indicator is lit when you turn the power on. The indicator color differs
depending on the monitor's operation status.
Green: Monitor in operation, Orange: Power saving mode,
Off: Main power / power off
Connect this port to the PC when you use software that needs a USB connection or
connect a USB device (peripheral device that supports USB) to the USB downstream
port.
Connect to a PC.
For more information, see "2-2. Connecting Cables" (page 15).
To set up a daisy-chain connection, connect the cable to the DisplayPort input
connector of another monitor. For more information, see "2-2. Connecting Cables"
(page 15).
Connects the power cord.
Connect it to a USB device. To set up a daisy-chain connection, connect the cable
to the USB upstream port of another monitor. For more information, see "2-2.
Connecting Cables" (page 15).
The height and angle can be adjusted.
Turns the main power on or off.
: On, : Off,
Complies with Kensington's MicroSaver security system.
Holds the monitor cables.
6 7 8
12
13
14
15
9 10
13
Chapter 1 Introduction