Sagem SAGEMFAST 1500WG Reference Manual page 64

4 - Configuring the SAGEM F@st™ 1500 ADSL router
QoS Class
PCR/SCR/MBS
IP assigned by
ISP
IP Address
Subnet Mask
Connect Type
Idle Time (Minute)
Username
Password
Confirm
Password
MTU
The following parameters only appear in "Routed" mode that you can select in the "Protocol"
field:
Default Gateway
DHCP Client
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Reproduction and communication prohibited without the written permission of E
Page 4-18
• CBR Constant Bit Rate. It is used for voice application.
• VBR Variable Bit Rate. It is used for video application.
• UBR Unspecified Bit Rate. It is used in Best Effort for IP and Ethernet (for Data
Application)
• PCR Peak Cell Rate, defined in number of cells / second.
• SCR Sustainable Cell Rate, defined in number of cells / second..
• MBS Maximum Burst Size, defined in number of cells / second..
Click Yes or No to assign or no IP address to your ISP
IP address of the ATM interface.
Subnet mask of the ATM interface.
• Always connected
• Auto - Triggered by traffic
•Manual - Start in Disconnected
• Manual - Start in Disconnected
• Manual - Start in Last State
Enter the maximum idle time for the Internet connection. After this time has been exceeded the
connection will be terminated.
In the field it appears the username that you entered during the SETUP WIZARD menu
In the field it appears the Password that you entered during the SETUP WIZARD menu
In the field it appears the Confirm Password that you entered during the SETUP WIZARD menu
Specifies the maximum size of the payload data in IP packets as a number of bytes (default
value is 1400).
Default gateway of the ATM interface.
Check this box if your ISP assigns an IP to clients using DHCP.
Your router is always connected to the WAN (automatic
mode).
Your router only connect to WAN when traffic is on
(automatic mode).
When your router start, this is disconnected to WAN
(Manual mode).
When your router start, this is connected to WAN (Manual
mode).
When your router start, this connect to WAN in last stated
(Manual mode).
E
E E