Pin Assignments; C.1.4 Pin Assignments - Sagem SAGEMFAST 1500WG Reference Manual

C.1.4

Pin Assignments

General
With 100BASE-TX/10BASE-T cable, pins 1 and 2 are used for transmitting data, and pins 3 and
6 for receiving data.
Pin Number
1
2
3
6
The "+" and "-" signs represent the polarity of the wires that make up each wire
pair.
Straight-Through Wiring
If the port on the attached device has internal crossover wiring (MDI-X),
then use straight-through cable.
Straight Through Cable Pin Assignments
End 1
1 (Tx+)
2 (Tx-)
3 (Rx+)
6 (Rx-)
Crossover Wiring
If the port on the attached device has straight-through wiring (MDI), use crossover cable.
Crossover Cable Pin Assignments
End 1
1 (Tx+)
2 (Tx-)
3 (Rx+)
6 (Rx-)
Reproduction and communication prohibited without the written permission of E
RJ45 Pin Assignments
Assignment1
Tx+
Tx-
Rx+
Rx-
End 2
1 (Tx+)
2 (Tx-)
3 (Rx+)
6 (Rx-)
End 2
1 (Rx+)
2 (Rx-)
3 (Tx+)
6 (Tx-)
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Appendix C - Cables
E
E E
Page C-3