Table of Contents
Advertisement
Appendix E - Default configuration
This section gives the default factory settings for the SAGEM F@st™ 1500. The
SAGEM F@st™ 1500 is set to "Router" mode by default.
These default settings can be modified by a special pre-configuration of the
SAGEM F@st™ 1500.
E.1
Default user name and password
Password
E.2
Default configuration on the local area network side
LAN characteristics
IP characteristics
IP - SERVICES
"Wireless" characteristics
Only
TM
SAGEM F@st
E.3
Default configuration on the wide area network side
WAN characteristics
ATM characteristics
SAGEM F@st™ 1500 Reference Manual - 288053220-03
Reproduction and communication prohibited without the written permission of E
Page E-2
Empty
IP address
Mask
BROADCAST, ARP, MULTICAST
RIP
DHCP server activated on the LAN
SSID broadcasting
ESSID
1500WG
Channel
WEP
Keys
Function - Mode
Protocol
VPI
VCI
Encapsulation
CLASS
NAT
Default route
DNS relay
Firewall
Intrusion detection
OAM F4 and F5 (see Note)
Function - Mode
IP/PPP/ATM
8
35
VC MUX
Traffic-type CBR
PCR 800 000 bit/s
Enabled
ADSL interface address
Enabled
Enabled
Disabled
Enabled
State/Value
192.168.2.1
255.255.255.0
Enabled
Disabled
192.168.2.2 to 192.168.2.254
Enabled
"SAGEM"
6 (when channels 1 to 13)
10 (when channels 10 to 13)
Enabled
64 bits / Hex / Key1
(01/01/01/01/01)
State/Value
E
E
E
Advertisement
Table of Contents
