Address Setting; Setting The Address - Mitsubishi Electric MELSEC FX2N-32DP-IF Hardware Manual

FX2N-32DP-IF Profibus-DP Interface Unit
4.

Address Setting

4.1

Setting the Address

The slave address of 32DP-IF for Profibus network is set by the ON/OFF configuration of DIP
switches. Slave address setting range is 0 ~ 126. When 32DP-IF's power supply is turned ON,
the slave address is the sum total of these DIP switch values.
Figure 4.1: DIP Switches
T his D IP sw itch is not
used for the address
setting. P lease leave in
the O F F position.
Note:
If the address of 32DP-IF is changed, the 32DP-IF must be turned OFF and ON again in
order to activate the new address.
T hese D IP
sw itches are O F F .
Address Setting 4
T his is the D IP sw itch value.
O N
O F F
T his D IP sw itch is O N .
4-1