System Configuration - Mitsubishi Electric MELSEC FX2N-32DP-IF Hardware Manual

FX2N-32DP-IF Profibus-DP Interface Unit
1.3

System Configuration

Figure 1.3: System Configuration
Slave or
1
DP-master *
FX
2N
interface unit *
*1 The units at each end of the Profibus-DP network must have a terminating resistor. This
will either be in the master, slave unit or in the Profibus connector.
*2 For connecting a monitoring tool, refer to subsection 1.3.1
*3 For connecting units/blocks, refer to subsection 1.3.2.
Caution
The parameter data of the 32DP-IF must be set correctly in the DP-master, if the parameter
data is not correct, the operation of the module may be affected.
For parameter of 32DP-IF, refer to FX
DP-master
-32DP-IF Profibus-DP
2
Profibus-DP network
Extension I/O units/blocks and
special function blocks *
-32DP-IF User's Manual.
2N
Introduction 1
Slave or
1
DP-master *
3
1-5