Installing A Mim - HP A6616 Installation Manual

Table of Contents

Figure 4-30 Loosen the captive screws

Step4

Pull the two ejector levers at both ends of the HIM outward to release the HIM, and then pull

the HIM out along the slide rails.

Figure 4-31 Pull out the HIM

Before pulling a HIM out of a slot, loosen all the two captive screws. Otherwise, the panel of the

Before pulling a HIM out of a slot, loosen all the two captive screws.



HIM may be seriously deformed.

To protect the removed HIM, place it in an antistatic bag.



If you do not install a new HIM in the same slot, install two HIM blank panels to prevent dust



from entering the chassis. For how to install a blank panel, refer to "

Blank

Panel" on page 4-38.

Installing and Removing a MIM

Installing a MIM

Follow these steps to install a MIM:

Step1

Face the front panel of the router.

Step2

Locate the slot where you will install the MIM.

Step3

Remove the blank panel from the position where you will install the MIM. For how to remove

the blank panels, refer to

Loosen the captive screws

Pull out the HIM

assis. For how to install a blank panel, refer to

"Installing and Removing a Blank Panel

Installing and Removing a Blank

Otherwise, the panel of the

"Installing and Removing a

Installing and Removing a

Panel" on page 4-38.

38.

Table of Contents