Technical Specifications - HP A6616 Installation Manual

Figure 1-20 Front view of the FIP-200
(1) Slot 1
(3) Combo interface 0
(5) OPEN BOOK sign
"OPEN BOOK" sign – Refer to related sections when performing the following operations:
Operation
Plug/unplug a FIP-200
Plug/unplug an interface module
Connect an Ethernet cable
Plug/unplug an optical fiber

Technical specifications

Table 1-23 Technical specifications for the FIP-200
Item
Processor
Processor cores
Flash
Memory type and size
NVRAM
Combo interfaces
HIMs
MIMs
Dimensions (H × W × D)
Hardware encryption
(2) Slot 2
(4) Combo interface 1
"Installing and Removing a FIP" in Chapter 4 "Installing the Router"
"Installing and Removing a HIM" and "Installing and Removing a
MIM" in Chapter 4 "Installing the Router"
"Connecting the Management Ethernet Interface" and "Connecting
Ethernet Cables" in Chapter 4 "Installing the Router"
"Connecting an optical Ethernet interface" in Chapter 4 "Installing
the Router"
MIPS 1 GHz
8
4 MB
DDR2 SDRAM
1 GB (default, two 512 MB memory modules)
2 GB (maximum, 1.5 GB not supported)
Memory modules must be used in pairs. Make sure they are of the same type
and size.
128 KB
2
2 electrical interfaces
(automatic MDI/MDI-X)
2 optical interfaces
2
2
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Supported
Reference
Specifications
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex