8. If the cable pass through hole is beneath the mounting bracket, you will need to install
the hole cover after you have routed all cables. Place the hole cover over the mounting
bracket cable pass thru hole and align with holes drilled in step 6a. Insert the #8 Phillips
countersink wood screws. Hand tighten only.
NOTE: Be sure that the cables pass through the slots on the hole cover and that there is enough cable
slack to allow for the control head to pivot through its full tilt range. Extra cable slack will also help when
connecting or disconnecting the cables.
1
Gimbal Mounting Bracket
2
Hole Cover
1
Gimbal Mounting Bracket
2
Grommet
3
Hole Cover
9. Thread the cables through the opening in the back of the cable collector cover.
Installation - Gimbal Mount
Cables Routed Directly Beneath Mounting Bracket
1
Cables Routed Behind Mounting Bracket
2
3
2
12
1