Section 5 − Installation; Selecting A Location (All Models); Remote Receptacle For Optional Foot Control - Miller DIVERSION 165 Owner's Manual

5-1. Selecting A Location (All Models)

Movement
Location And Airflow
18 in. (460 mm)
18 in. (460 mm)

5-2. Remote Receptacle For Optional Foot Control

NOTICE − Use this receptacle to connect the dedicated optional foot control only. Connecting other types of equipment to this receptacle may damage
your machine.
8
1
805113-A
.
A complete Parts List is available at www.MillerWelds.com
SECTION 5 − INSTALLATION
3
18 in. (460 mm)
18 in. (460 mm)
Socket*
1
A
2
3
4
6
Foot Select 5
7
8
1
2
4
Socket Information
Command reference; +10 volts DC output to remote control.
0 to +10 volts DC input command signal from remote control.
Remote control circuit common.
15 volts DC.
Contact closure to 4 completes 15 volts DC contactor control
circuit.
Foot control select; jumper to 7 in foot control.
Chassis common.
Not Used
1 Handles
Use Handles to lift welder; get help
if necessary.
2 Cart
Place welder on cart to move unit.
3 Tipping
!
Do not move or operate unit
where it could tip.
4 Line Disconnect Device
Locate unit near correct input pow-
er supply.
Position unit so air can circulate.
For information about sources of
high-frequency see Section 9.
For carts and caster kits see back
of book or contact your distributor.
!
Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
805468-C
OM-263920 Page 13