Resetting The Unit; How To Reset The Remote Controller - Onkyo TX-NR545 Manual

Troubleshooting
Resetting the unit
Resetting the unit to the status at the time of shipment may solve the
problem. If the measures mentioned in the troubleshooting do not solve the
problem, reset the unit with the following procedure. If you reset the unit
status, your preferences will be reset to the defaults. Note them down before
starting reset.
How to reset
1. While holding down CBL/SAT on the main unit (note that step 2 must be
performed with this button pressed down)
2. Press ON/STANDBY on the main unit. "Clear" is appeared on the
display and the unit will enter standby mode.
How to reset the remote controller
1. While holding down 1 RECEIVER on the remote controller (note that
step 2 must be performed with this button pressed down)
2. Press and hold 2 Q for 3 or more seconds until the 3 remote indicator
stays lit. Within 30 seconds, press 1 RECEIVER again.