Resetting The Unit - Onkyo TX-NR 838 Manual

Troubleshooting

Resetting the unit

Resetting the unit to the status at the time of shipment may solve the
problem. If the measures above do not solve the problem, reset the unit with
the following procedure. If you reset the unit status, your preferences will be
reset to the defaults. Note them down before starting reset.
How to reset
1. While holding down CBL/SAT on the main unit (note that step 2 must be
performed with this button pressed down)
2. Press ON/STANDBY on the unit. "Clear" is appeared on the display
and the unit will enter standby mode.
How to reset the remote controller
1. While holding down 1RCV on the remote controller (note that step 2
must be performed with this button pressed down)
2. Press and hold down 2 HOME until the 3 remote indicator lights (about
3 seconds). Within 30 seconds, press 1RCV again.