Location And Function Of Controls; Rear Panel Terminology; Front Panel Terminology - Runco DTV-992 ULTRA Owner's Operating Manual

2
Comm Port Port 3
Off On
Power/Mains
1
2 3

REAR PANEL TERMINOLOGY

1
Power Switch: press the switch to turn the projector ON.
Depending on the hardware set-up of the projector during
installation, the projector switches to 'Standby' or to 'Opera-
tional' mode. If in standby, the standby LED lights up.
2
AC Power Input
3
Communication Port
• allows connection of a remote IR receiver unit to the
projector.
4
Port 3
RGB Analog Input (9 pin female sub D connector). Allows a
character generator, microcomputer, etc. having analog
RGB outputs to be connected to the projector.
5
Port 4/5: RGB-S Input (5x BNC connector):
RGB-S input: allows a character generator, microcomputer,
video camera, etc. having analog RGB Output to be con-
nected to the projector.
Line inputs
– signals RED-GREEN-BLUE
– COMPOSITE sync. signal
– Tri level sync. signal (option>)
RS232 IN RS232 OUT IR REMOTE
IN RS232 OUT RS232 IR REMOTE
12 13 14
11

FRONT PANEL TERMINOLOGY

11
RS 232 Input Port
Connection between the DTV-992 / 992 ULTRA and an IBM
PC (or compatible) Or MAC (RS422) for remote computer
control and data communication.
12
RS 232 Output Port
RS232 Input Port allows a communication link for PC 0r
MAC to the next projector in a series of projector.

LOCATION AND FUNCTION OF CONTROLS

R G B Comp/ VSYNC
HSYNC
4 5 6 7
15
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation.
VIDEO Green=Oper.
Red=Stby
8 9 10
6
S-VIDEO Input: (Not Active)
7
75 ohm Termination Switch for S-Video signals
8
VIDEO Input: (Not Active)
9
75 ohm Termination Switch for Video signals:
(Not Active)
10
Projector Pilot Lamp: indicates the Status of the
projector.
– unlit: mains (power) switch is not pressed.
– lit: mains (power) switch is pressed and the
indicated color shows the projector mode:
Green color : operational mode of the projector.
Red color: standby mode of the projector.
13
IR Sensor
receiver for control signals transmitted from the
RCU.
14
IR Remote
Connector for remote input for hard wired remote
Control.
15
EYE-Q Camera
2-1