Calling Up - Mercedes-Benz R 350 Operator's Manual

Features
280
same programming steps with this remote
control. Before performing these steps,
make sure that new batteries have been
installed in garage door drive remote
control A.
Note that some remote controls only
R
transmit for a limited amount of time (the
indicator lamp on the remote control goes
out). Press button B on remote control
A again before transmission ends.
Align the antenna cable of the garage door
R
opener unit. This can improve signal
reception/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of
the garage door system remote control.
Please also read the operating instructions
for the garage door system.
Turn the SmartKey to position 2 in the
X
ignition lock.
Press button ;, = or ? which you have
X
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp : lights up green.
Garage door system with a rolling code:
indicator lamp : flashes green.
i
The transmitter will transmit a signal as
long as the button is pressed. The
transmission is halted after a maximum of
ten seconds and indicator lamp : lights
up yellow. Press button ;, = or ? again
if necessary.
Clearing the memory
Turn the SmartKey to position 2 in the
X
ignition lock.
Press buttons ; and ?.
X
The indicator lamp lights up yellow.
Press and hold buttons ; and ? until the
X
indicator lamp turns green.
i
Make sure that you clear the memory of
the integrated garage door opener before
selling the vehicle.
Compass
Calling up the compass
Repeatedly press the V or U button
X
on the multifunction steering wheel until
the AIRMATIC/Compass
the multifunction display.
The compass shows which direction the
vehicle is currently traveling in: N, NE, E, SE,
S, SW, W or NW.
i
If your vehicle does not have an AIRMATIC
package, the multifunction display only
shows the compass.
Floormat on the driver's side
G
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
menu appears in