Examples Using The Ascend-Data-Filter Attribute - Juniper E320 Configuration Manual

Examples Using the Ascend-Data-Filter Attribute

This section provides examples showing the configuration of policies that use the
Ascend-Data-Filter attribute.
In this example, the following Ascend-Data-Filter attribute creates a RADIUS record
Example 1
that configures an input policy. The policy filters all packets from network 10.2.1.0
with wildcard mask 0.0.0.255 to any destination. The values specified in the
Ascend-Data-Filter attribute are listed in
Table 7: Ascend-Data-Filter Example 1 Values
Action or Classifier
Type
Forward
Indirection
Spare
Source IP address
Destination IP address
Source IP mask
Destination IP mask
Protocol
Established
Source port
Destination port
Source port qualifier
Destination port qualifier
Reserved
Use the show classifier-list and show policy-list commands to view information
about the policy:
Ascend-Data-Filter="01000100 0A020100 00000000 18000000 00000000 00000000"
Hex Value
01
00
01
00
0a020100
00000000
18
00
00
00
0000
0000
00
00
0000
host1#show classifier-list
IP clin_5_00.1 ip 10.2.1.0 0.0.0.255 any
host1#show policy-list
IP Policy plin_5
Administrative state: enable
Reference count:
Classifier control list: clin_5_00, precedence 100
filter
Referenced by interface(s):
ATM4/0.0 input policy, statistics enabled, virtual-router default
Table 7.
Actual Value
IP
Forward
Ingress
None
10.2.1.0
Any
24 (0.0.0.255)
0 (255.255.255.255)
None
None
None
None
None
None
None
Classifier Control List Table
---------- ------- ---- -----
Policy Table
------ -----
1
Applying Policy Lists to Interfaces and Profiles
Chapter 2: Creating Policies
! 69