Classifier Control List Commands - Juniper E320 Configuration Manual

Table 4: CLACL Criteria (continued)
Type of CLACL
VLAN
You configure CLACLs with a name and then values to match in the IP datagram
header. A CLACL does not include an action: actions take place when a match is
included in a policy list.

Classifier Control List Commands

Use the commands in this section to create or modify CLACLs.
atm classifier-list
!
NOTE:
used as a wildcard for the classifier-group command.
!
!
!
Criteria
!
Color
!
Traffic class
!
User packet class
!
User priority
Use to create or modify a classifier control list that can only be use in ATM
policy lists.
Do not use the asterisk (*) for the name of a classifier list. The asterisk is
Use the following keywords to configure the list:
! traffic-class—Matches packets with a class that you defined using the
traffic-class command
! color
green—Matches packets with color green, indicating a low drop
"
preference
yellow—Matches packets with color yellow, indicating a medium drop
"
preference
red—Matches packets with color red, indicating a high drop preference
"
! user-packet-class—Matches packets with the specified user packet class
value
! clp—Matches ATM CLP bits with the specified CLP value
Example
host1(config)#atm classifier-list atmclassifier color red user-packet-class 10
clp 1
Use the no version to remove the classifier control list.
Chapter 2: Creating Policies
Creating Classifier Control Lists
! 9