Monitoring Packet Mirroring - Juniper E320 Configuration Manual

JUNOSe 7.2.x Policy Management Configuration Guide
host1#show snmp trap
Enabled Categories: CliSecurity, PacketMirror, Sonet
SNMP authentication failure trap is disabled
Trap Source: FastEthernet 6/0, Trap Source Address:192.168.120.78
Trap Proxy: enabled
Global Trap Severity Level: 6 - informational
Address
---------------
192.168.1.1
10.16.2.12
192.168.57.162
Address TrapSeverityFilter
--------------- ------------------ ------- --------- --------- -------------
192.168.1.1 5 - notice
10.16.12.12 5 - notice
192.168.57.162 2 - critical

Monitoring Packet Mirroring

baseline radius dynamic-request
186 !
Monitoring Packet Mirroring
! Ver—SNMP version (v1 or v2) of the SNMP trap packet
! Port—UDP port on which the trap recipient accepts traps
! Trap Categories—Types of traps that the trap recipient can receive
! TrapSeverityFilter—Severity level filter for this SNMP host
! Ping TimeOut—Configured ping timeout in minutes
! Maximum QueueSize—Maximum number of traps to be kept in the trap
queue
Queue DrainRate—Maximum number of traps per second to be sent to the
!
host
! Queue Full discrd methd—Method used to discard traps when the queue is
full:
dropFirstIn—Oldest trap in the queue is dropped
"
dropLastIn—Most recent trap is dropped
"
! Example—Text in bold indicates secure packet mirroring trap configuration
information, which is visible only if the mirror-enable command is enabled.
Security String
--------------------------------
host1
secureHost
host2
Ping
TimeOut QueueSize DrainRate discrd methd
1
1
1
This section describes the commands you can use to view your CLI-based and
RADIUS-based packet mirroring environments.
Use in RADIUS-based packet mirroring to set a statistics baseline for packet
!
mirroring–related RADIUS statistics. The E-series router implements the
baseline by reading and storing the statistics at the time the baseline is set and
then subtracting this baseline when you retrieve baseline-relative statistics.
! Use the delta keyword with the show radius statistics command to show
baselined statistics.
Ver Port Trap Categories
--- ----- ----------------
v1 162 Cli
v3 162 CliOspfPacketMirrorSonet
v3 162 Sonet
Maximum Queue Queue Full
32 0 dropLastIn
32 0 dropLastIn
32 0 dropLastIn