Symbols In The Illustration; Check Items When Turning Off The Main Power; Points To Note When Relocating The Host Machine; Product Name - Canon Staple Finisher-S1 Service Manual

How to Check this Installation Procedure

Symbols in the Illustration

The frequently-performed operations are described with symbols in this procedure.
Screw
1x
Unused Parts
Packaged Item
Install
Harness Connector
(Common for Guides and Clamps)
1x
1x 1x
Connect
Remove
Install
Power
Check the sound Check visually
ON OFF

Check Items when Turning OFF the Main Power

Check that the main power switch is OFF
1) Turn OFF the main power switch of the host machine.
2) Be sure that display in the Control Panel and the lamp of the main power supply are turned
off, then disconnect the power plug.
6
Installation > Product Name
1x 1x
1x
Tighten Loosen
Remove
Power Cord
1x
Connect
Disconnect
Disconnect
Check Push Cleaning
6 Installation > Product Name

Points to Note When Relocating the Host machine

CAUTION:
If this machine with the Reinforcing Plate Cover is moved, followings may occur.
• Possibility of damaging customer's floor (carpeting, etc.)
• Possibility of overturning
Refer to the following Staple Finisher-S1 Service Manual Chapter 4 "Parts Replacement
and Cleaning Procedure" > "Removing the Equipment" > "Removing the Finisher Unit
from the Connected Equipment", "Removing the Reinforcing Plate Cover from the
Connected Equipment" for the procedure of removal.
F-6-1

Product Name

Safety regulations require the product's name to be registered. In some regions where this
product is sold, the following name may be registered instead.
• F711400
6-2
F-6-2
6-2