Reviewing And Changing; Programs; Manual Override - Trane IntelliPak SCWF 20 Installation, Operation And Maintenance Manual

I I n n s s t t a a l l l l a a t t i i o o n n - - E E l l e e c c t t r r i i c c a a l l
8. Press "��" key to enter run mode.
Reviewing and Changing Programs
Use the following instructions to review and change

programs:

1. To review a program at any time, press "Prog." key.
Programs display in the sequence they were
entered with repeated presses of "Prog." key.
2. To change a program, select that program as
outlined in step 1. Enter the time of day and days of
week just as in the programming steps above.The
old program is overwritten with the new selections.
Press "Prog." to store the new program.
3. To delete an individual program, select the program
as in step 1 and press "h" and "m" keys until "—:
—" appears in the display. Press either "Prog." or
"¹" key until"—:—" flashes.The program is deleted
after a few seconds.
56

Manual Override

While in the "run" mode ("��" symbol is displayed),
pressing the "��" key will reverse the load status
(switch load off if it is on, or switch it on if it is off). A
hand symbol appears in the display to indicate the
override is active. At the next scheduled switching
time, automatic time control resumes, eliminating the
override.
Pressing the "��" key a second time "◉" appears in the
display indicating the load is permanently on.
Pressing the "��" key a third time "❍" appears in the
display indicating the load is permanently off.
Pressing the "��" key a fourth time returns to
automatic, "��" appears in the display.
All days shown in the respective blocks will switch on
(or off) at the selected hour and minute.
SCXF-SVX01Q-EN