Honeywell PRO32E1PS Assembly And Installation Instructions Manual page 7

8. Using the provided #8x32 screw and locknut, secure the provided ground wire (GREEN with
YELLOW stripe) to the back of the metal plate as shown below:
9. Take the input power cord with LED and insert the LED into the panel enclosure as shown below.
Note: LED MUST be installed BEFORE the power inlet.
10. Once the LED is installed and fully seated, install the AC power inlet into the panel. See the photo
below:.
LED
AC
Power
Inlet
Document 800-08279, Revision A
February 2011
7 of 12 © Honeywell International. All rights reserved.
Installation Instructions