Dhw Tank; Safety Information; General Information - Samsung AE090MNYDEH Installation Manual

DHW tank

DHW tank should be purchased separately (not supplied).

Safety information

(Before installing a DHW Tank, please read this manual
thoroughly to ensure that you know how to safely and
efficiently install a new appliance.)
WARNING
• If you don't follow the safety precautions, you may get the
risk of serious wound or death.
• The installation must be done by the manufacturer or
its service agent or a qualified person in order to avoid a
hazard.
– Installation by an unqualified person may cause a water
leakage, electric shock or fire and so on.
• The electric work must be done by service agent or
qualified persons according to national wiring regulations
and use only rated cable.
– Use certified power cable in the market suggested here
and do electric work according to installation manual
otherwise, electric shock or fire may occur.
• Install the outdoor unit correctly according to the
installation manual.
– An incorrect installation may cause a water leakage,
electric shock or fire and so on.
• Manufacturer is not responsible for accidents due to
incorrect installation.
• Use certified parts in the market and supplied parts from
the factory.
– All wiring, components and materials to be procured
on the site must comply with the applicable local and
national codes. If you don't use the certified parts and
tools, it can cause trouble to the Air to Water Heat pump
and bring into injury.
• Install the DHW Tank on a hard and even place that can
support its weight.
– If the place cannot support its weight, the outdoor unit
may fall down and it may cause injury.
40
English
• Fix the outdoor unit securely on foundation it can fall over
strong wind or earthquake.
– If the outdoor unit is not properly fixed, it turns over and
accidents may occur.
• Secure power cable with a conduit, which is accessory part
for DHW tank, not to be pulled out by external force.
– If fixing is incomplete, it can cause trouble with a heat
generation, electric shock or fire and so on.

GENERAL INFORMATION

• The piping, valves and system configuration of DHW tank
system should be followed a relevant local or national
regulations.
• A pressure relief valve in accordance with an opening
pressure of max. 0.9MPa should be connected.
• The electrical box must be opened by a licensed electrician.
• Switch off the power supply before opening the electrical
box lid.
• Make sure that the installation location of DHW tank
system including piping and valves is frost free.
CAUTION
• DHW Tank shall be located and installed indoors (garage,
multipurpose room, boiler room).