Roland Sonar V-Studio VS-700 Owner's Manual page 76

Controlling Plug-ins from the VS-700C Console
To Control Plug-in Parameters
1.
In the CHANNEL STRIP CONTROL section, press the [ACT] button to enable ACT mode.
2.
As described below, place the focus on the plug-in that you want to control.
To switch ACT context to the first FX in the selected
channel strip's FX bin
To switch ACT context to the first synth in the Synth
Rack
To navigate to other ACT contexts
3.
Use the rotary encoders and buttons in the CHANNEL STRIP CONTROL section to control the
desired parameter(s).
You can also use the T-bar to control a single ACT parameter. For more information about using the T-bar, refer
to "T-Bar Section" (p. 69).
76
Hold down the [SHIFT] modifier button and press the
[ACT] button in the CHANNEL STRIP CONTROL section.
Hold down the [CTRL] modifier button and press the [ACT]
button in the CHANNEL STRIP CONTROL section.
Hold down the [COMMAND] modifier button and press
the [PAGE LEFT] or [PAGE RIGHT] button.