Random Pan Depth; Tone Pan; Pan Keyfollow - Roland Sonar V-Studio VS-700 Owner's Manual

Creating a Patch
Bias Direction
Selects the direction in which change will occur starting from
the Bias Position.
Value
LOWER: The volume will be modified for the keyboard
area below the Bias Point.
UPPER: The volume will be modified for the keyboard
area above the Bias Point.
LO&UP: The volume will be modified symmetrically
toward the left and right of the Bias Point.
ALL: The volume changes linearly with the bias point
at the center.
Tone Pan ★
Sets the pan of the tone. "L64" is far left, "0" is center, and
"63R" is far right.
Value: L64–0–63R

Pan Keyfollow

Use this parameter if you want key position to affect panning.
Positive (+) settings will cause notes higher than C4 key
(center C) to be panned increasingly further toward the right,
and negative (-) settings will cause notes higher than C4 key
(center C) to be panned toward the left. Larger settings will
produce greater change.
Value: -100– +100
fig.06-040.e
Pan
R
o
L
C1 C2 C3 C4
114
+100
+50
0
-50
-100
Key
C5 C6 C7

Random Pan Depth

Use this parameter when you want the stereo location to
change randomly each time you press a key. Higher settings
will produce a greater amount of change.
Value: 0–63
Alternate Pan Depth
This setting causes panning to be alternated between left
and right each time a key is pressed. Higher settings will
produce a greater amount of change. "L" or "R" settings will
reverse the order in which the pan will alternate between left
and right. For example if two tones are set to "L" and "R"
respectively, the panning of the two tones will alternate each
time they are played.
Value: L63–0–63R
When any value from Type "2"–"10" is selected for the
Structure parameter in the Pan KF, Rnd Pan Depth, Alter
Pan Depth parameter settings, the output of tones 1
and 2 are joined in tone 2, and the output of tones 3 and
4 are joined in tone 4. For this reason, tone 1 will follow
the settings of tone 2, and tone 3 will follow the settings
of tone 4 (p. 101).