Roland JUNO-Di Owner's Manual page 94

Effects List
About Note
Some effect settings (such as Rate or Delay Time) can be specified in
terms of a note value. The note value for the current setting is shown
following the numerical value.
* If the Rate is specified as a note value, the modulation will be
synchronized with the tempo when you play back SMF song data.
note:
fig.MFX-note2.e_88
Sixty-fourth-note triplet Sixty-fourth note
Thirty-second note Sixteenth-note triplet
Eighth-note triplet
Sixteenth note
Eighth note Quarter-note triplet
Quarter note Half-note triplet
Half note Whole-note triplet
Whole note Double-note triplet
Double note
If you specify the delay time as a note value, slowing down the
tempo will not change the delay time beyond a certain length.
This is because there is an upper limit for the delay time; if the
delay time is specified as a note value and you slow down the
tempo until this upper limit is reached, the delay time cannot
change any further. This upper limit is the maximum value that
can be specified when setting the delay time as a numerical
value.
Chorus Send and Reverb Send
The depth of chorus and reverb applied to the sound processed by the
multi-effect is determined by the "Effect Edit" settings "Cho Send Level"
and "Rev Send Level."
For details, refer to "Editing the Effects (MFX/Chorus/Reverb) (Effect
Edit)" (p. 61).
94
01:
This is a three-band stereo equalizer (low, mid, high).
Item
Low Gain
Mid Gain
High Gain
Level
Thirty-second-note triplet
Dotted thirty-second note
02:
Dotted sixteenth note
This is a stereo spectrum. Spectrum is a type of filter which modifies the
Dotted eighth note
timbre by boosting or cutting the level at specific frequencies.
Dotted quarter note
Item
Dotted half note
Band (250Hz)
Band (1000Hz)
Dotted whole note
Band (4000Hz)
Level
03:
This is an equalizer which cuts the volume greatly, allowing you to add a
special effect to the sound by cutting the volume in varying ranges.
Item
Boost/
Cut Low
Boost/
Cut Mid
Boost/
Cut High
Level
04:
Boosts the volume of the lower range, creating powerful lows.
Item
Boost Gain
Level
EQUALIZER
Value
-15–+15 dB
-15–+15 dB
-15–+15 dB
0–127
SPECTRUM
Value
-15–+15 dB
0–127
ISOLATOR
Value Description
These boost and cut each of the High,
Middle, and Low frequency ranges.
-60–+4 dB At -60 dB, the sound becomes
inaudible. 0 dB is equivalent to the
input level of the sound.
0–127 Output Level
LOW BOOST
Value Description
Amount by which the lower range will be
0–+12 dB
boosted
0–127 Output level
Description
Gain of the low range
Gain of the middle range
Gain of the high range
Output Level
Description
Gain of each frequency band
Output Level