System Installations; Installing Mmp1 & Nuage I/O Units - Yamaha MMP1 Setup Manual

4. System Installations

4-1. Installing MMP1 & Nuage I/O units
First, connect MMP1, Nuage I/O and Dante Accelerator to the network switch.
UNIT ID Configuration
In case of using more than one MMP1 or Nuage I/O unit, assign a unique ID number to each
unit from 1 - 8. For assigning UNIT ID, simply rotate the rotary switch on the rear panel.
[UNIT ID on MMP1] [UNIT ID on Nuage I/O]
Connecting LAN cables
For most LAN connections, use CAT5e or CAT6 cables. For connecting Dante Accelerator
to the LAN switch, it is recommended to use CAT7 STP (Shielded Twisted-Pair) cables.
For connecting multiple MMP1/Nuage I/O units and the switch, there are 3 ways to do so
(Refer to the manual for how to choose each mode). Depending on the requirement, choose
from the following:
1. Redundant mode (Primary port only)
2. Redundant mode (Primary/Secondary ports)
3. Daisy chain mode
19