Configuring And Running Each Program; Configuring Dante Patching - Yamaha MMP1 Setup Manual

Hide thumbs Also See for MMP1:

Table of Contents

6. Configuring and running each program

Audio signals between MMP1, Nuage I/O and PC are routed through Dante audio network.

Configuration of Dante audio network can be done by using the Dante Controller.

Below is the Dante patching required for this example:

1. Patch Dante output 1-12 of MMP1 to Dante input channel 1-12 of Nuage I/O (Large +

Small + Studio Speakers + 3x Cue).

Note: If the Dante devices are either not correctly displayed on the Dante Controller or

no audio is heard even if patches are correctly made, check if the IP address of each

device is correctly configured (private/link local address, subnet mask etc.) and also the

sampling frequency setting is the same on each device.

[Patch MMP1 to Nuage I/O]

Table of Contents