System Software; Studio Manager - Yamaha ME2000 Owner's Manual

Memory expansion kit

G Note About Versions and Upgrades

System software:

The ME2000 includes system version 1.20 or higher, and is not compatible with pre-V1.20 software.

Before upgrading your DM2000 again in the future, be sure that your updater program is V1.20 or

higher.

The ME2000 is not compatible with Studio Manager versions prior to V1.1.1. If your version is older

than V1.1.1, please replace it by installing the Studio Manager version included on the accompany-

ing CD-ROM. For information about how to carry out the installation, refer to Studio Manager's

installation guide.

Note that Macintosh system requirements are now as indicated in the table below.

Macintosh System Requirements

Computer

A Macintosh G3/233 MHz or better and a USB port

Mac OS 8.6 to 9.2.2 (Mac OS X not supported)

Memory

120 MB or more of free memory (Virtual memory must be turned off)

Hard Disk

7 MB or more

1024 × 768 pixels, 256 colors or higher

Display

1280 × 1024, 32,000 colors recommended

Other

OMS 2.3.3 or later

Note: If you are using a PowerBook on battery power, open the Energy Save

control panel, and in Advanced Settings, Additional Power Savings, turn off

Allow processor cycling.

For the latest information about System software and Studio Manager, please visit our website at:

www.yamahaproaudio.com.

G Save the Data from the DM2000

The board installation procedure will clear all DM2000 user memory, and will reset all DM2000 set-

tings to their defaults. Before starting installation, use the following procedure to save the data from the

DM2000 into an external MIDI device. You can then restore the data after completing the installation.

As alternatives, you can save the data directly into a SmartMedia card or you can use Studio Manager

to save the data into a computer. For details, refer to the DM2000 owner's manual or to the Studio

Manager owner's manual (PDF ﬁle).

Press the DISPLAY ACCESS [MIDI] key to open the Bulk Dump page.

Set CATEGORY to ALL, select the TRANSMIT button, and then press the [ENTER] key to

start the save.

ME2000