Setting Up Data Pages - Raymarine SmartPilot X-5R Drive Installation & Setup

52
The default page settings are:
Data Page
1
2
3
4
Remaining pages

Setting up data pages

When setting up your data pages, we recommend that you:
• Retain the BTW and DTW data pages. If your SPX-5R Drive system receives a
man overboard (MOB) message, these data pages will show the bearing and
distance to the MOB location.
• Disable data pages you do not need to NOT USED. These will then not be
displayed during normal operation, thereby improving the access time to the other
data pages..
.
Available Data Pages
Speed Knots
Log
Trip
Average Speed
Wind Direction
Wind Speed
Depth Metres
Depth Feet
Depth Fathoms
Heading
Water Temperature, Degrees C
Water Temperature, Degrees F
Course Over Ground
Speed Over Ground, Knots
Cross Track Error
Distance to Waypoint
SmartPilot X-5R Drive Installation and Setup Guide
Default Setting
XTE (Cross Track Error)
BTW (Bearing to Waypoint) - see Note below
DTW (Distance to Waypoint) - see Note below
RESPONSE
NOT USED (see Setting up data pages below)
Displayed as
SPEED KTS
LOG XXXX.X
TRIP XXX.X
AV. SPD
e.g. WIND PORT
WIND KTS
DEPTH M - see Note below
DEPTH FT - see Note below
DEPTH FA - see Note below
HEADING
WATER °C - see Note below
WATER °F - see Note below
COG
SOG KTS
XTE
DTW