Step 2 - Check Data Connections; For Details Of Supported Nmea Sentences, See Appendix 1: Nmea 0183 Sentences; Step 3 - Checking Rudder Bar Operating Sense - Raymarine SmartPilot X-5R Drive Installation & Setup

Chapter 3: Commissioning & Setup
Startup problems
• If the Pilot Controller does not beep or the display is blank, switch off the power,
then check the fuse/circuit breaker and the SeaTalk fuse in the SPX Course Com-
puter.
• If the display shows the SEATALK FAIL or NO PILOT alarm message, check the
SeaTalk connections.
• If the STANDBY screen does not display a live compass heading, check the sensor
connections.

Step 2 - Check data connections

Pilot controller
Check the SmartPilot controller links as follows:
• With on the Pilot Controller switched on, check that the Pilot Controller display
shows STANDBY.
• If this does not happen or if the display shows NO PILOT, check the cabling and
connections between the Pilot Controller and the other units.
SeaTalk and NMEA GPS or Chartplotter
If you have connected the SPX-5R Drive system to a chartplotter or GPS (e.g. via
NMEA or SeaTalk), check the links by displaying the default navigation data pages on
the Pilot Controller:
1. Press disp to display the first data page (
expected data.
2. Press disp again to check each successive data page (BTW, DTW etc)
If the display shows dashes instead of data values, ensure:
• The GPS or chartplotter is switched on and transmitting active waypoints.
• The GPS or chartplotter is configured to transmit the required data format.
• There is not a cabling error. Check for open circuit, short circuit or reversed
connections.
Other NMEA connections
To check other NMEA connections, you will need to set up the appropriate page of
data using Dealer calibration mode.
Data pages are viewed by pressing the disp key (when in Standby or Auto mode).

For details of supported NMEA sentences, see Appendix 1: NMEA 0183 sentences

Step 3 - Checking rudder bar operating sense

If a rudder reference transducer is fitted, check the rudder bar operating sense as
follows:
1. Turn the wheel manually to starboard.
2. Check that the rudder bar on the controller display moves to starboard.
If the rudder bar moves the wrong way:
i. Turn off the power.
ii. Reverse the red and green wires connected to the RUDDER inputs on the
SPX Course Computer.
iii. Switch on the power and re-check.
XTE
), and check that this page shows the
33