Omron NA5-12W series Hardware User Manual page 69

Wiring Procedure
Use the following procedure to connect the power supply.
1
Remove the sheath from the power supply wires.
7 mm
2
Remove the power supply connector from the NA Unit and loosen the terminal block screws.
3
Insert the wires all the way to the back of the connector and then turn the screws clockwise to
secure the wires.
Use a small flat-blade screwdriver and tighten the screws to between 0.5 and 0.6 N·m.
+24 V
4
Attach the power supply connector to the NA Unit.
NA-series Programmable Terminal Hardware User's Manual (V117)
0 V
Power line
3 Installation and Wiring
3
3 - 11