Installing Freestanding Installation (With Ballast - For Model Sh Only) - Viessmann Vitosol 100-FM SV1F Installation, Operating And Service Instructions

Vitosol 100-FM/200-FM Installation, Operating and Service
Installing Freestanding Installation
Note: Use the base rails as a drilling template.
Collector model SH inches
Note: See page 16 for numbered component description.
X
75f 18
(mm) (1920)
(481)
(with ballast - for Model SH only)
1. Observe the max. load and distance from the edge
of the roof for on-site substructure.
Y
CAUTION
A structural engineer must be consulted to ensure that
the existing roof structure is capable of carrying the
additional weight of the collectors, insert weights and
support slabs.
2. Remove any gravel etc. from the installation area,
cover the surface with protective building mats or
foam insulation and position concrete slabs on top
of the mats or insulation.
3. Secure the support base rail 2 (use as drilling
template) onto the concrete slabs (bolts supplied
by others).
4. Secure retaining bracket 9 to the bottom of all
collector supports; do not yet tighten screws.
5. Secure support braces qQ onto the retaining
plates between the second and third, the fourth
and fifth supports etc. Tighten all bolts.
Installation on Flat Roofs
or Freestanding Installation
21