Mitsubishi SD200U Service Manual page 13

6. Removal of IRR PCB ASSY
1. Remove the Front Grill following "1. Removal of FRONT
GRILL".
2. Remove the Top Case Assy following "2. Removal of
TOP CASE ASSY".
3. Remove the two (a) screws and the Rear Grill Assy as
shown in Fig. 3-5.
4. Remove the (b) screw and IRR PCB ASSY as shown
in Fig. 3-5.
7. Removal of OPTICAL UNIT
1. Remove the Front Grill following "1. Removal of FRONT
GRILL".
2. Remove the Top Case Assy following "2. Removal of
TOP CASE ASSY".
3. Remove the (a) screw and the PFC Holder as shown in
Fig. 3-6-1.
4. Remove the Connector J3 as shown in Fig. 3-6-1.
5. Remove the seven (b) screws and the OPTICAL UNIT
as shown in Fig. 3-6-2.
Rear Grill Assy
Connector J3
- 11 -
IRR PCB ASSY
b x1
a x2
Fig. 3-5
PFC Holder
a x1
Fig. 3-6-1