Follett Horizon Elite HCD710A Operation And Service Manual page 24

31. Insert screwdriver into groove of auger shaft and pry
shaft outwards (Fig. 30.1).
32. Insert retainer into groove (Fig. 30.2), ensure that
retainer is aligned with hole in spacer.
33. Install screw and tighten (Fig. 31.1).
34. Connect gear motor wires and ground wire.
24
Fig. 30
1
Fig. 31
1
Fig. 32
GROUND SCREW
2
GRAY
WHITE
HCD710A, HMD710A