Operation - Dimplex DF3015 Service Manual

Operation

The manual controls for the fireplace are located in the lower
right hand corner (Figure 1).
Figure 1
A. Main On/Off Switch
Supplies power to the Three Position Manual Control Switch.
B. Three Position Manual Control Switch
Remote (right position): The unit is operated with the
remote control.
Flame (center position): The flame effect is turned on.
Flame & Heat (left position): The flame effect and heater
are turned on simultaneously. When the manual control is
in the Flame & Heat position the heater does not run on
the remote operated thermostat.
!
NOTE: When the manual control switch is in the Flame
and Flame & Heat positions, the fireplace unit will not
operate with the remote control.
C. Initialization Button
Used to synchronize the supplied remote control with the
fireplace.
Remote Control
The remote control has a range of approximately 50 feet
(15.25 m), it does not have to be pointed at the fireplace
and can pass through most obstacles (including walls). It
is supplied with 243 independent frequencies to prevent
interference with other units.
Battery Installation/Replacement
1. Depress tab on the battery cover on the back of the
remote transmitter and remove battery cover.
2. Install/replace two (2) AAA batteries into the remote
control.
3. Ensure Child Lock is in the "unlocked" position (Figure 2).
A
B
4. Replace the battery cover.
!
NOTE: When the "BAT"
symbol is present on the
remote control it is
recommended to replace the
batteries promptly, to maintain
full functionality of the remote/
fireplace. The remote transmitter
has a battery backup time of
only several hours.
Remote Control Initialization
1. Plug cord into a 120 Volt wall outlet.
2. Ensure the Main On/Off Switch located in the switch box
on the fireplace in the lower right hand corner is in the On
C position.
3. Set the Three Position Manual Control (Figure 1B) to the
Remote position (right position).
4. Press and hold the Initialization Button on the unit
(Figure 1C).
5. While holding the Initialization Button, press the Flame/
Heat On/Off button or the Purifire™ On/Off button on
the remote control transmitter.
6. Release the Initialization Button on the unit.
7. Press the Flame/Heat On/Off button
Heat function on or press the Purifire™ On/Off button to
turn the Purifire™ function
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic switch will turn the
heater off and it will not come back on without being reset.
The temperature cutoff switch can be reset by unplugging the
unit, waiting five (5) minutes and plugging the unit back
CAUTION: If you need to continuously reset the heater,
unplug the unit and call Dimplex North America Limited
at 1-888-346-7539. Please have your model and serial
number ready when calling.
3
Figure 2
Batteries
Child Lock
to turn the Flame/
on.
in.