Heat & Glo ATS-AU-D Installation And Operation Instructions Manual page 6

MODEL
ATS-AU-D
TABLE 1
WARNING: THE EXHAUST PIPE
MUST ONLY BE CONNECTED TO THE
EXHAUST STARTING COLLAR OF
THE UNIT AND THE CENTER COLLAR
OF THE TERMINATION CAP.
THE INLET AIR PIPE MUST ONLY BE
CONNECTED TO THE INLET AIR
COLLAR OF THE UNIT AND ATTACHED
TO THE INLET AIR COLLAR OF THE
TERMINATION CAP.
FIGURE 3
6
FLUE TERMINATION APPROVAL
LINK-DV30B
EXHAUST
AIR FLUE PIPE
Heat & Glo • ATS-AU-D • 327-900 Rev. D • 2/06
VERTICAL TERMINATION CAP
TERMINATION CAP
V
= 3.0m (10 FT.) MINIMUM
10m (40 FT.) MAXIMUM
INLET AIR
FLUE PIPE