Accessories; Maintenance Instructions; Motor Brush Replacement; Lubrication - RIDGID 700 Operator's Manual

No. 700 Portable Power Drive

Accessories

Only the following RIDGID products have
WARNING
been designed to function with the 700 Power Drive.
Other accessories suitable for use with other tools may
become hazardous when used on this Power Drive. To
prevent serious injury, use only the accessories listed
below.
Accessories For Power Drive
Model No.
Description
770
Adapter for 00-R & 00-RB
771
Adapter for 0-R
772
Adapter for 11-R
773
Adapter for 111-R
774
Square Drive Adapter
775
Support Arm for No. 700 Power Drive
B-171-X
Metal Carrying Case for No. 700 & Accessories
418
Oiler w/1 Gal. Nu-Clear Thread Cutting Oil
—
Gearhead Motor Grease
NOTE! See Ridge Tool catalog for listing of pipe sup-
ports, vises and thread cutting oil.
Threaders:
Drop Head Threaders
12-R
00-R
11-R
00-RB
Geared Threaders
141 2 1 / " – 4" Pipe (NPT or BSPT)
2
161 4" – 6" Pipe (NPT or BSPT)
Contact a RIDGID distributor or consult the Ridge Tool
catalog for specifications and catalog numbers.

Maintenance Instructions

WARNING
Make sure Power Drive is unplugged from power
source before performing maintenance or mak-
ing any adjustments.
10

Motor Brush Replacement

Check motor brushes every 6 months and replace brush-
es when they are worn to less than

Lubrication

Grease face gear and bearings every 3 to 6 months
depending upon the amount of use. Grease fitting is pro-
vided on the gear housing.

Tool Storage

WARNING
indoors or well covered in rainy weather. Store the Power
Drive in a locked area that is out of reach of children
and people unfamiliar with power drives. This power tool
can cause serious injury in the hands of untrained users.

Service and Repair

Service and repair work on this Power Drive must be
performed by qualified repair personnel. Tool should be
taken to a RIDGID Independent Authorized Service
Center or returned to the factory. All repairs made by
Ridge Tool Co. service facilities are warranted against
defects in material and workmanship.
WARNING
identical replacement parts should be used. Failure to fol-
low these steps may create a risk of electrical shock or
other serious injury.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
Ridge Tool Company
1 / ".
4
Motor-driven equipment must be kept
WARNING
When servicing this Power Drive, only