Configuring The Core Builder 7000 Family Atm Switch; Logging In To The Lma - 3Com CoreBuilder 7000 Installation & Start?Up Manual

6
Logging in to the
LMA
C
ONFIGURING THE
C B
ORE UILDER
S
WITCH
This chapter describes the initial configuration of the CoreBuilder
family ATM switch. Using the terminal connected to the control port, you
log into the system and assign network addresses to the CoreBuilder
7000 family ATM switch. This procedure enables the management of the
site to recognize and communicate with the CoreBuilder 7000 family
ATM switch. You also specify ATM connections between addresses, using
the ATM protocol you have selected.
The topics covered in this chapter include:

Logging in to the LMA

Integrated Fast Setup
Additional Switch Configuration
Viewing Network Statistics.
Storing and Retrieving Configuration Parameters
Upgrading from E-IISP to PNNI
When you boot the CoreBuilder 7000 family ATM switch the following
login screen appears:
-------------------------------
- CoreBuilder 7000
-
- ATM Backbone
-------------------------------
Access level (read, write, admin):admin
Password:
7000 F
AMILY
-
-
Switch -
ATM
®
7000