Additional Switch Configuration - 3Com CoreBuilder 7000 Installation & Start?Up Manual

C 6: C
72
HAPTER ONFIGURING THE
Accept Changes
=-------------
*** Note: Change of some parameters will take effect now!!
Save changes (Y/N)? Y
Prompt to
Are you sure (Y/N)? y
save changes
Saving NMS parameters...
Saving the
Saving LE parameters...
switch
Saving Network Prefix...
configuration
Saving resident LECS Address...
Saving active LECS Address...
Saving NNI parameters...
The switch new configuration has been saved.
Some changes will be effective only after reboot.
Saving the
Now applying the module in slot #4 ...
edge device
configuration
Due to new VN configuration, some saved static
entries in slot #4 have been invalidated.
The new VN configuration in slot #4 has been applied and saved.
Now applying the module in slot #5 ...
The new VN configuration in slot #5 has been applied and saved.
Prompt for
All the modules new configuration has been applied.
reboot
Reboot the system
This will reset and reboot the device!
Are you sure (Y/N)? y
*** System will reboot in about one minute...
Additional Switch
Configuration
C B 7000 F
ORE UILDER
(Y/N)? y
The Integrated Fast Setup configures a minimum set of network
parameters - enough to get you started.
If you need to make changes or to perform additional configuration
tasks, use individual items of the LMA menus. These are all described in
the CoreBuilder 7000 Family ATM Switches Management Guide.
Some additional configuration tasks might be:
ATM S
AMILY WITCH