Loading Software And Configuration Data By Utilities - 3Com CoreBuilder 7000 Installation & Start?Up Manual

7 Verify the success status of the download by the LMA menu item:
Loading Software
and Configuration
Data by Utilities
Loading, file name switch/cfg/24_7_cfg.1, file type Box
Profile
Load process of file type Box Profile completed successfully
(1) SYS:\ (3) LOA: \(1) STS
The download status is displayed as follows:
Load process completed successfully.
The status will be "success" only if all the files were successfully loaded.
In case of failure to load a file, the "load all" process will be stopped
without continuing to the next file, a failure indication is displayed, and
the display status option will display the error message:
General Error occurred while loading
The following commands allow you to use RS-232 batch-file utilities to
download and upload the executable software and the system
configuration parameters for the CoreBuilder 7000 family ATM switch to
an external disk via the RS-232 service port.
This ability allows you to easily restore the configuration to a switch
which has failed or to configure a new switch with a standard
configuration stored on disk.
The appropriate batch file is run via the RS-232 service port. Table 18
shows the utilities and the batch file names.
Table 18 Utilities for Upload/Download
Utility
General flash utility
Format all configuration parameters groups in flash
memory according to the mapping of version 4.0
Upload all configuration parameters groups from the
switch engine flash memory to PC file
Download all configuration parameters groups from
PC file to the switch engine flash memory
Upload a configuration parameter group from the
switch engine flash memory to PC file
Storing and Retrieving Configuration Parameters 81
Batch file name
fls_utl.bat
cfgfrmat.bat
cfg_upld.bat
cfg_down.bat
grp_upld.bat