Cisco UC 320W Administration Manual page 55

System Readiness
System Readiness Summary
Unified Communications UC 320W Administration Guide
To manually set the System Time:
If the System Time is not automatically displayed, you can manually set the time.
Click Set System Time. Enter the current date and time, and then click Continue.
Note that this feature is available only if the Unified Communications System was
unable to automatically get the time settings from the specified NTP server.
To continue after a failed WAN test:
• If you have the WAN connection information from your ISP, return to the
WAN page and enter the correct settings. If you are missing any required
information, contact your ISP
• If the WAN test fails and you do not have an active Internet connection at this
time, you can click Skip Apply and Test Step to continue to the next step of
the process. At any point, you can click the Backup / Save Session link to
save your work. Later, you can reload your session and configure your WAN
connection.
3
55