Install Small Bullet Cameras; What's Included; Install Camera - Uniden 4KTPD-MVF Installation Manual

6. Unscrew the access cover and swing it open. Unscrew the
adjustment levers just enough to move them and adjust the
image. Check the camera view through the NVR Preview
screen.
• Zoom - Move lever to the left for Telephoto (zoom in) and to the
right for Fish-Eye (zoom out).
• Focus - Move lever to left and right to adjust focus.
7. Tighten the adjustment lever screws when complete and close
the compartment.

INSTALL SMALL BULLET CAMERAS

What's Included

• IP camera
• Mounting template sticker
• Camera-specific Allen wrench
• 2-wire to 2.1mm barrell plug for optional 12V DC power input
• Installation screws and anchors
• Dessicant package
• Rubber plug (grommet) to seal network cable hole

Install Camera

1. Remove the camera and installation items from the box. Verify that all parts are there.
2. Position the installation template at the location (wall, ceiling, etc). Drill a 1" hole as indicated
on the sticker and install the anchors provided.
3. Thread the network cable tail through the grommet and connect
it to the house cabling through the 1" hole. Plug the grommet
into the hole. Using the screws provided, screw the camera
base into position.
When using an optional external power supply, the AC
socket outlet shall be installed near the equipment and be
If installed outdoors, the cable and all cable connections
must be routed inside the wall.
4. Loosen screw 1 to rotate the camera and stand up to 360°.
Loosen screw 2 to adjust the camera body up to 90° and
screw 3 to fine tune the camera position up to 90°. Check the
camera's position through the NVR Preview screen as you
adjust the camera.
5. Once positioned, tighten all screws to secure.
easily accessible.
Cover
Focus
Zoom
Red - 12VDC (optional)
2.1mm Barrel Adapter
NOTE: 12VDC power supply
not included
RJ45
Screw 1
Screw 2
Screw 3
PoE
13