Table of Contents
Advertisement
HS-360X Wireless Handheld DPM Scanner
Connecting the Cradle
Note: The interface cable and power supply (if necessary) in the following order to ensure
proper operation of the scanner and cradle.
To connect the HS-360X Cradle:
1. Connect the appropriate cable to the power supply and an AC power source, if necessary.
2. Insert the interface cable into the host port.
3. Lift the latch and connect the interface cable into the cradle's host port and then close
the latch.
4. If applicable, thread the interface cable over the cable support hook and run the host
cable into the cable groove.
5. Pair the scanner to the cradle either by inserting it in the cradle (if pair on contacts is
enabled), or by scanning the pairing symbol.
6. If necessary, scan the appropriate host symbol (for non-autodetected interfaces). See
the specific host chapter.
Latch
Connecting the Cables to the Cradle
Note: Always disconnect the DC power supply BEFORE disconnecting the cable to
the host end or the cradle may not recognize the new host.
Note: Different cables are required for different hosts. The connectors illustrated in
each host chapter are examples only. The connectors may be different from those
illustrated, but the steps to connect the scanner remain the same.
1-6
Host Port
(Under Latch)
Important: Be sure that the
interface cable is pushed all
the way into the host port
before you close the latch.
HS-360X Handheld DPM Scanner User Manual
Advertisement
Table of Contents
