Table of Contents
Advertisement
„ Listening Modes
• To enjoy digital surround playback in formats such as Dolby Digital, you need to make a connection for audio signals with an HDMI cable, digital
coaxial cable or digital optical cable. Also, audio output need to be set to Bitstream output on the connected Blu-ray Disc player, etc.
• Press
on the remote controller several times to switch the display of the main unit, and you can check the input format.
Check the following if the problem persists after you have confirmed the above.
❏ Cannot select a desired listening mode
• Depending on the current source, settings and status of the unit, some listening modes may not be selected. Refer to "Selecting a Listening
mode" in "Listening Mode".
❏ Cannot listen to the sound in Dolby TrueHD or DTS-HD Master Audio format
• If the audio in Dolby TrueHD or DTS-HD Master Audio format cannot be output correctly in the source format, set "BD video supplementary
sound" (or reencode, secondary sound, video additional audio, etc.) to "Off" in the setting of a connected Blu-ray Disc player, etc. After changing
the setting, switch the listening mode to that for each source, and confirm.
„ Video
• Confirm that the connection between the output jack on the connected device and the input jack on this unit is correct.
• Make sure that none of the connecting cables are bent, twisted, or damaged.
• When the TV image is blurry or unclear, the power cord or connection cables of the unit may have interfered. In such a case, keep distance
between TV antenna cable and cables of the unit.
• Check the switching of the input screen on the monitor side such as a TV.
Check the following if the problem persists after you have confirmed the above.
❏ No image appears.
• Change the input selector on this unit to the position of the jack to which the player is connected.
• Images from the VIDEO IN jack (analog) are not output from HDMI. Images from the HDMI jack are not output from MONITOR OUT (analog). Use
the same type of jack and cable for input and output.
❏ No image from a device connected to HDMI IN jack
• To display video from the connected player on the TV while the unit is in standby, you need to enable "5. HDMI Setup" - "c. Standby Through" in
the Setup menu.
• Normal operation with an HDMI-DVI adapter is not guaranteed. In addition, video signals output from a PC are not guaranteed.
Contents
Preparation
≫
72
Front Panel≫ Rear Panel≫ Remote≫
Playback
Setup
≫
≫
p53)
(
(
p65)
≫
Hide quick links:
Advertisement
Chapters
Table of Contents
