Initial Setup
Turning the power on
TV's REMOTE
Inputs
INPUT
TV
HDMI 1
HDMI 2
HDMI 3
Contents
Preparation
≫
After all the connections are completed, set the Automatic Speaker Setting
(AccuEQ Room Calibration) (
unit and the TV are connected with an HDMI cable, use the OSD (On-Screen
Display) that appears on the TV to make the settings. Switch the input on the TV
to the input connected to the unit.
• When you do not use an HDMI cable but use an analog video cable to connect
with the TV, the operation screens cannot be displayed on the TV. In such a
case, see the display of the main unit to make the settings.
1. Switch the input on the TV to the input connected to the unit.
2. Put the batteries in the remote controller, and press the
unit.
31
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
≫
p34) and HDMI setting (
p36). When this
button to turn on this
Setup
≫